Dry-wipe the windshield 10 minutes
For LUPHYX full hydrophobic silicone wipers. New install: wash and dry the glass, fit the new wiper, then dry-wipe. Already fitted, beading faded: wash and dry, then dry-wipe again.
New wiper install
- Wash the front windshield thoroughly with water or washer fluid.
- Dry it completely with a clean towel.
- Remove the old full wiper and fit the LUPHYX wiper.
- Dry-wipe the glass about 10 minutes (no water, no detergent).
- Spray water to check: rain should bead and slide off.
Later restore
- Glass must be clean and dry.
- Dry-wipe about 10 minutes to transfer/restore coating on the glass.
- Repeat when beading fades.
Note: Dry-wipe is only to transfer coating from the LUPHYX hydrophobic wiper onto the glass. It is not a step before AUTOGO HD coating. For coating, only clean, rinse and dry fully. See the coating guide.
雨刷干刮前挡风 10 分钟
适用于 LUPHYX 整支疏水硅胶雨刷。换新雨刷:先清洗抹干前挡,装好后再干刮。已装好、成珠减弱:同样先清洗抹干再干刮。
换新雨刷
- 用清水或玻璃水彻底清洗前挡风。
- 用干净毛巾完全抹干。
- 拆下旧雨刷,装上 LUPHYX 整支新雨刷。
- 干刮前挡约 10 分钟(不喷水、不用清洁剂)。
- 喷水试刮,雨水应成珠滑落。
日常恢复
- 前挡须清洁干燥。
- 干刮约 10 分钟,把雨刷镀膜转移到玻璃上。
- 成珠减弱时可重复。
注意:干刮只用于把 LUPHYX 疏水雨刷上的疏水涂层转到前挡。涂 AUTOGO HD 镀膜前不需要干刮,只需清洁、冲洗并完全擦干。镀膜步骤见 镀膜指南。
Lap kering cermin 10 minit
Untuk wiper silikon hidrofobik LUPHYX. Pemasangan baharu: cuci dan keringkan kaca, pasang wiper, kemudian lap kering. Sudah terpasang, beading pudar: cuci dan keringkan, kemudian lap kering semula.
Pasang wiper baharu
- Cuci cermin hadapan dengan teliti (air atau cecair pencuci).
- Keringkan sepenuhnya dengan tuala bersih.
- Tanggal wiper lama, pasang wiper LUPHYX.
- Lap kering kira-kira 10 minit (tiada air, tiada detergen).
- Sembur air untuk semak: air patut mengelek dan meluncur.
Pulihkan kemudian
- Kaca mesti bersih dan kering.
- Lap kering kira-kira 10 minit untuk pindah/pulih salutan pada kaca.
- Ulang bila beading pudar.
Nota: Lap kering hanya untuk pindah salutan dari wiper hidrofobik LUPHYX ke kaca. Ia bukan langkah sebelum AUTOGO HD coating. Untuk salutan, cuci, bilas dan keringkan sahaja. Lihat panduan salutan.